Fusion AWD V6-3.0L (2009)
Brake Pad: Testing and Inspection
Brake System Inspection
Brake Pads
NOTE: It is not required to install new brake pads when the brake discs are machined.
1. Inspect the brake pad friction material for contamination.
-
If the friction material shows evidence of contamination, install new brake pads.
2. Inspect and measure the thickness of the brake pad friction material. For additional information, refer to Specifications.
-
Minor surface cracks do not require pad replacement, however, if there are missing chunks or cracks in the lining through to the backing plate,
install new brake pads.
-
If the thickness of the friction material is less than the specified thickness, install new brake pads.
-
If the friction material shows taper wear that is not within specifications, install new brake pads and verify the caliper guide pins are
functioning correctly. For additional information, refer to Brake Caliper Guide Pins inspection. See: Testing and Inspection/Component Tests
and General Diagnostics/Brake System Inspection/Brake Caliper Guide Pins
