Fusion AWD V6-3.0L (2009)
-
If a leaking or damaged caliper piston boot is found, install a new brake caliper.
5. NOTICE: The caliper guide pin boots must be seated correctly on the anchor plate or the guide pins may become contaminated.
Inspect the guide pin boots and make sure they are seated on the anchor plate correctly. The boot has a lip that fits under the edge of the anchor
plate extension.
6. NOTE: During installation, make sure that the brake caliper hose does not become twisted.
To install, reverse the removal procedure.
-
Install new copper washers.
-
Bleed the brake caliper.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
1. Remove the brake pads. For additional information, refer to Brake Pads See: Disc Brake System/Brake Pad/Service and Repair/Front Disc Brake.
2. Remove the 2 brake caliper anchor plate bolts.
-
To install, tighten to 90 Nm (66 lb-ft).
3. Remove the brake caliper anchor plate.
4. To install, reverse the removal procedure.
-
Apply brakes several times to verify correct brake operation.
Rear Disc Brake
Brake Caliper
