Fusion AWD V6-3.0L (2009)
2. Release the fuel system pressure.
3. Remove the engine coolant degas bottle.
4. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold See: Service and Repair/Removal and
Replacement/Lower Intake Manifold.
5. Remove the bolt and position aside the ground wire.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove the bolt and damper.
-
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the engine mount bracket bolt.
-
To install, tighten to 115 Nm (85 lb-ft).
8. Install the Universal Adapter Brackets and the Engine Lifting Brackets.
1. Position the 2 Universal Adapter Brackets on top of the cylinder block.
2. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).
3. Position the Engine Lifting Bracket onto the 2 Universal Adapter Brackets.
4. Fasten the Engine Lifting Bracket to the 2 Universal Adapter Brackets with a suitable nut and bolt.
9. Install the Engine Support Bar and raise the engine 25 mm (0.98 in).
10. Remove the 3 engine mount bracket nuts.
-
To install, tighten to 63 Nm (46 lb-ft).
