Fusion AWD V6-3.0L (2009)
8. Remove the 8 lower intake manifold bolts and the lower intake manifold.
-
Remove and discard the gaskets.
Installation
1. NOTICE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the
intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions can result in
engine damage.
NOTE: Clean and inspect all sealing surfaces.
Using new gaskets, install the lower intake manifold and the 8 bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
2. Connect the 6 fuel injector electrical connectors.
3. Attach the 3 pin-type retainers to the fuel rail.
4. Attach the 2 wiring harness retainers to the RH and LH valve cover stud bolts.
5. Connect the fuel supply tube quick connect coupling at the fuel rail.
6. Install the upper intake manifold. For additional information, refer to Upper Intake Manifold See: Service and Repair/Removal and
Replacement/Upper Intake Manifold.
7. Connect the battery ground cable.
