Fusion AWD V6-3.0L (2009)
5. Disconnect the heater hose from the coolant pump.
6. Disconnect the coolant pump-to-engine hose and position aside.
7. Remove the 3 bolts from the coolant pump assembly.
8. Reposition the coolant pump-to-thermostat housing hose clamp and remove the coolant pump and hose as an assembly.
Installation
1. Connect the coolant pump-to-thermostat housing hose and reposition the clamp.
2. Position the coolant pump assembly and install the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
-
Tighten the 3 bolts an additional 90 degrees.
3. Connect the coolant pump-to-engine hose and the heater hose.
4. NOTICE: Failure to use the correct Camshaft Pulley Installer, assembled as shown in the illustration, will result in damage to the coolant
pump pulley and/or the Camshaft Pulley Installer.
Install the Camshaft Pulley Installer on the camshaft as shown in the illustration.
-
Adjust the collar on the Camshaft Pulley Installer to get the best thread engagement in the rear of the camshaft.
5. NOTICE: Failure to use the correct Power Steering Pump Pulley Installer, Camshaft Pulley Installer and Water Pump Pulley Spacer
assembled as shown in the illustration, will result in damage to the coolant pump pulley and/or the Power Steering Pump Pulley Installer,
Camshaft Pulley Installer and Water Pump Pulley Spacer.
NOTE: Only the roller collared nut from the Power Steering Pump Pulley Installer is used on the Camshaft Pulley Installer.
