Fusion AWD V6-3.0L (2009)
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 25 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test D. See: Pinpoint Test D: The Restraints Control Module (RCM) Does Not Respond to the Scan Tool
No
INSTALL the removed fuse. GO to U14.
-------------------------------------------------
U14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE OCCUPANT CLASSIFICATION SYSTEM MODULE
(OCSM) DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 24 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not Respond to
the Scan Tool
No
INSTALL the removed fuse. An intermittent fault is not present. Go To Pinpoint Test S. See: Pinpoint Test S: Intermittent No Medium Speed
Controller Area Network (MS-CAN) Communication, One Or More Modules Are Not Respo
-------------------------------------------------
Pinpoint Test V: No Power to the Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test V: No Power To The Scan Tool
Refer to Wiring Diagram Set 14, Module Communications Network for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
The scan tool is connected to the Data Link Connector (DLC) to communicate with the High Speed Controller Area Network (HS-CAN) and the
Medium Speed Controller Area Network (MS-CAN) communications network. Voltage for the scan tool is provided by circuit SBP11 (BU/RD). Ground
is provided by both circuits GD116 (BK/VT).
This pinpoint test is intended to diagnose the following:
-
Fuse
-
Wiring, terminals or connectors
-
Scan tool
PINPOINT TEST V: NO POWER TO THE SCAN TOOL
