Fusion AWD V6-3.0L (2009)
Transmission Position Switch/Sensor: Adjustments
FNR5
Transmission Range (TR) Sensor Adjustment
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the Transmission Range (TR) sensor electrical connector and the selector lever cable end.
3. NOTICE: Failure to hold the selector lever, while loosening or tightening the manual control lever, will transmit rotational torque to the
Transmission Range (TR) sensor causing internal damage.
Loosen the TR sensor (the automatic transaxle is shown removed for clarity).
1. Remove the nut and the manual control lever.
2. Loosen the TR sensor bolts.
4. Using the Transmission Range Sensor Alignment Tool, align the TR sensor and tighten the bolts.
-
Tighten to 10 Nm (89 lb-in).
5. NOTICE: Do not use air tools on this nut. Hold the manual control lever while tightening the manual control lever nut, or damage to the
manual control lever shaft or the Transmission Range (TR) sensor could occur.
Install the manual control lever.
-
Tighten to 22 Nm (16 lb-ft).
