Fusion AWD V6-3.0L (2009)
Door Module: Service and Repair
Driver Door Module (DDM)
Removal and Installation
NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information
needs to be downloaded into the new module once installed.
1. NOTE: This step is necessary only if the Driver Door Module (DDM) is being replaced.
Upload the module configuration information from the DDM into the scan tool.
2. Remove the driver door trim panel.
3. Remove the 2 nuts.
-
To install, tighten to 3 Nm (27 lb-in).
4. Disconnect the 2 electrical connectors and remove the DDM.
5. To install, reverse the removal procedure.
-
NOTE: If the DDM was not replaced, this substep will not be necessary.
Download the DDM configuration from the scan tool into the new DDM.
