Fusion AWD V6-3.0L (2009)
All Occupant Classification Sensor (OCS) weight sensor assemblies
1. Remove the passenger seat.
Outboard OCS weight sensor assembly
2. If equipped, remove the manual lumbar control knob.
3. If equipped, remove the spring clip and the manual recliner handle.
4. NOTICE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become
damaged during removal and may not remain attached if reinstalled. Install a new side shield (includes new retainers attached).
Remove and discard the cushion side shield.
-
If equipped, remove the scrivet.
-
Pull out on the side and rear of the cushion side shield and release the retainers.
-
Separate the wire harness from the cushion side shield.
-
Remove the side shield and any remaining side shield retainers from the seat and discard.
Seat receiving a new OCS weight sensor assembly
5. Remove the bolt and the forward seat riser from the affected side OCS weight sensor assembly.
6. Remove the 2 bolts and the rearward seat riser from the affected side OCS weight sensor assembly.
All OCS weight sensor assemblies
7. NOTE: Note the position and the routing of the OCS system electrical wiring and connector for installation.
On the affected side, disconnect the OCS weight sensor assembly electrical connector.
8. If equipped, disconnect the power seat track motor electrical connector.
9. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
10. Remove the 2 rear bolts from the affected OCS weight sensor assembly.
11. Move the seat to the rearward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
12. Remove the 2 front bolts and the OCS weight sensor assembly.
Installation
