Fusion AWD V6-3.0L (2009)
1. Remove the nut and the manual control lever.
2. Remove the bolts and the TR sensor.
Installation
1. NOTICE: Failure to hold the manual control lever, while loosening or tightening the manual control lever nut, will transmit rotational
torque to the Transmission Range (TR) switch causing internal damage.
NOTE: Do not fully tighten the TR bolts at this time.
Install the TR sensor and loosely install the bolts (the automatic transaxle is removed for clarity).
2. Using the Transmission Range Sensor Alignment Tool, align the TR sensor and tighten the bolts.
-
Tighten to 10 Nm (89 lb-in).
3. NOTICE: Do not use air tools on this nut. Hold the manual control lever while tightening the manual control lever nut, or damage to the
manual control lever shaft or the Transmission Range (TR) sensor could occur.
Install the manual control lever.
-
Tighten to 22 Nm (16 lb-ft).
