Fusion AWD V6-3.0L (2009)
All Occupant Classification Sensor (OCS) weight sensor assemblies
NOTE: If installing a new seat track, position it so the seat will be in the rearward most position before installing the OCS weight sensor assembly.
1. NOTE: To make sure of correct installation, the OCS weight sensor assembly bolts must be installed in the sequence shown.
While holding the OCS weight sensor assembly firmly in position, install the OCS weight sensor assembly front mounting position rear bolt.
-
Tighten to 25 Nm (18 lb-ft).
2. While still holding the OCS weight sensor assembly firmly in position, install the OCS weight sensor assembly front mounting position front bolt.
-
Tighten to 25 Nm (18 lb-ft).
3. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
4. Install the 2 rear OCS weight sensor assembly bolts.
-
Tighten to 25 Nm (18 lb-ft).
5. Connect the OCS weight sensor assembly electrical connector.
6. Center the seat track to the seat cushion pan.
-
If equipped with a power seat track, apply power and ground to the pins shown.
7. If equipped, connect the power seat track motor electrical connector.
Seat receiving a new OCS weight sensor assembly
8. Install the rearward seat riser and the 2 bolts.
-
Tighten to 25 Nm (18 lb-ft).
9. Install the forward seat riser and bolt.
-
Tighten to 25 Nm (18 lb-ft).
Outboard OCS weight sensor assembly
10. NOTICE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become
damaged during removal and may not remain attached if reinstalled. Install a new side shield (includes new retainers attached).
Install a new cushion side shield.
11. If equipped, install the spring clip and the manual recliner handle.
12. If equipped, install the manual lumbar control knob.
All OCS weight sensor assemblies
13. Install the passenger seat. Do not prove out the SRS at this time.
