Fusion AWD V6-3.0L (2009)
6. Carefully lower the trailing arm and remove the jack.
7. NOTE: Position the shock absorber as necessary to remove the upper arm.
NOTE: When tightening the upper arm inboard bolt, the suspension must be at the bushing fastener tightening position.
Remove and discard the upper arm inboard bolt and remove the upper arm.
-
To install, tighten the new bolt to 100 Nm (74 lb-ft) and then rotate an additional 90 degrees.
8. NOTICE: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position. Use a
suitable jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 395 mm (15.55
in). This will prevent incorrect clamp load and bushing damage.
To install, reverse the removal procedure.
9. Check and, if necessary, adjust the rear camber.
