Fusion AWD V6-3.0L (2009)
Installation
1. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.
2. Install the TCM.
-
Tighten to 24 Nm (18 lb-ft).
3. Install the manual control lever.
4. Install the manual control lever nut.
-
Tighten to 12 Nm (106 lb-in).
5. Connect the TCM electrical connector.
6. NOTICE: Support the underside of the manual control lever when installing the selector lever cable or damage to the manual control
