Fusion AWD V6-3.5L (2010)
Catalytic Converter: Service and Repair
Catalytic Converter - LH
Catalytic Converter - 3.5L LH
Removal and Installation
1. NOTE: Always install new fasteners and gaskets as indicated. Clean flange faces prior to new gasket installation to make sure of proper sealing.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting. See: Maintenance/Vehicle
Lifting
2. Disconnect the Catalyst Monitor Sensor (CMS) electrical connector.
3. Remove the exhaust Y-pipe. For additional information, refer to Exhaust Y-Pipe - 3.5L See: Exhaust Pipe/Service and Repair/Exhaust Y-Pipe.
4. Remove the 2 catalytic converter support bracket-to-transmission bolts.
-
To install, tighten to 48 Nm (35 lb-ft).
5. Remove the 4 nuts and the LH catalytic converter.
-
Discard the 4 LH catalytic converter-to-exhaust manifold nuts and gasket.
-
To install, tighten to 40 Nm (30 lb-ft).
6. To install, reverse the removal procedure.
-
Install a new gasket, nuts and studs as indicated.
