ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3283 > < Initial Inspection and Diagnostic Overview|Page 3281
Page 104
background image

If the vehicle is equipped with an Interior Lighting Control Module (ILCM), GO to AC41. 

If the vehicle is not equipped with an ILCM, GO to AC42.

-------------------------------------------------
AC41 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ILCM DISCONNECTED

 

-

Disconnect: ILCM C2301 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AC62. 

No

GO to AC42.

-------------------------------------------------
AC42 VERIFY VEHICLE EQUIPMENT - DSM

 

-

Verify whether the vehicle is equipped with a Driver Seat Module (DSM).

-

Is the vehicle equipped with a DSM?

Yes

GO to AC43. 

No

GO to AC44.

-------------------------------------------------
AC43 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE DSM DISCONNECTED

 

-

Disconnect: DSM C3299d .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AC63. 

Initial Inspection and Diagnostic Overview|Page 3283 > < Initial Inspection and Diagnostic Overview|Page 3281