Fusion FWD L4-2.3L (2008)
Idler Pulley: Service and Repair
Accessory Drive Belt Idler Pulley
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 screws and position the RH fender splash shield aside.
3. Remove the 6 pin-type retainers and the RH splash shield.
4. Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the idler pulley.
^
To install, tighten to 25 Nm (18 lb-ft).
5. Loosen the bolt and remove the accessory drive belt idler pulley.
6. To install, reverse the removal procedure.
