Fusion FWD L4-2.3L (2008)
4. Position the power steering pump and install the 3 bolts.
5. NOTE: The coolant pump pulley bolts should be tightened after the accessory drive belt is installed.
Install the coolant pump pulley and bolts.
6. NOTE: Remove the through-bolt from the special tool.
NOTE: Lubricate the oil seal with clean engine oil.
Using the special tool, install the crankshaft front oil seal.
7. Install the engine mount.
8. Install the crankshaft pulley.
9. CAUTION: Only hand-tighten the bolt or damage to the front cover can occur.
Install a standard 6 mm (0.23 inch) x 18 mm (0.7 inch) bolt through the crankshaft pulley and thread it into the front cover.
