Fusion FWD L4-2.3L (2008)
4. Install the catalytic converter manifold shield bracket and the 2 bolts.
^
Tighten to 20 Nm (15 lb-ft).
5. Tighten the 2 catalytic converter manifold bracket bolts.
^
Tighten to 20 Nm (15 lb-ft).
6. Position the heat shield and install the 6 heat shield bolts.
^
Tighten to 10 Nm (89 lb-inch).
7. Install the 2 catalytic converter manifold-to-exhaust flexible pipe nuts.
^
Install a new gasket and nuts.
^
Tighten to 40 Nm (30 lb-ft).
8. Position the wiring harness bracket on the stud.
9. Install the HO2S and catalyst monitor sensors.
10. Install the generator air inlet duct.