Fusion FWD L4-2.3L (2008)
Catalytic Converter: Service and Repair
Catalytic Converter
Catalytic Converter - 2.3L, 3.0L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 2 exhaust flexible pipe-to-catalytic converter nuts.
^
Discard the gasket.
^
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the Torca(R) clamp.
4. Separate the catalytic converter from the muffler and tailpipe and remove the catalytic converter.
5. To install, reverse the removal procedure.
^
Install a new gasket and nuts.
6. Start the engine and check for exhaust leaks.