Fusion FWD L4-2.3L (2008)
4. Remove the bolt and position the battery cable body ground terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
5. Remove the nut and position the battery junction box (BJB) cable terminal aside.
-
To install, tighten to 8 Nm (71 lb-in).
6. Release the 2 battery cable locators from the battery tray.
7. Remove the bolt and position the battery cable transaxle ground terminal aside.
-
To install, tighten to 10 Nm (89 lb-in).
8. Remove the starter solenoid terminal cover.
9. Remove the nut and position the battery cable starter solenoid terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
10. Release the battery cable locator from the starter stud bolt.
11. Remove the 3 battery cable locators from the rear of the engine.
12. Remove the 2 nuts and the generator shield.
-
To install, tighten to 25 Nm (18 lb-ft).
13. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
14. Remove the battery cables.
15. To install, reverse the removal procedure.
