Fusion FWD L4-2.3L (2008)
8. Remove the 6 pin-type retainers (4 shown) and the LH splash shield.
9. If equipped, remove the bolts and the underbody cover shield.
^
To install, tighten 7 Nm (62 lb-in).
10. Remove and discard the 2 tie-rod end cotter pins and nuts.
^
To install, tighten to 48 Nm (35 lb-ft).
11. CAUTION: Do not use a hammer to separate the tie-rod end from the wheel knuckle or damage to the wheel knuckle can result.
NOTE: RH shown, LH similar.
Using the special tool, separate the 2 tie-rod ends from both wheel knuckles.
12. Remove and discard the 2 catalytic converter-to-exhaust flexible pipe nuts and separate the exhaust flexible pipe.
^
To install, tighten to 40 Nm (30 lb-ft).
All wheel drive (AWD) vehicles
13. Index the rear driveshaft-to-power transfer unit PTU).
^
Remove the 4 bolts and position the driveshaft aside.
^
To install, tighten to 70 Nm (52 lb-ft).