Fusion FWD L4-2.3L (2008)
3. Position the spring onto the lower arm with the end of the spring 0-10 mm (0-0.39 in) from the step on the spring seat.
4. NOTE: Do not tighten the bolt at this time.
Using the jack, raise the lower arm and install the lower arm outboard bolt.
5. CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position. This
will prevent incorrect clamp load and bushing damage.
Using the jack, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 395 mm (15.55 in).
