Fusion FWD L4-2.3L VIN Z (2007)
Front Bumper Reinforcement: Service and Repair
BUMPER - FRONT
Removal and Installation
1. Remove the front bumper cover.
2. Remove the front bumper isolator from the front bumper.
-
Pull the isolator rearward while releasing the retainers.
3. Remove the 6 front bumper bolts (3 each side).
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the 4 front bumper bolts from the radiator support (2 each side).
5. Remove the 2 front bumper stud nuts.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the front bumper.
7. To install, reverse the removal procedure.
