Fusion FWD L4-2.3L VIN Z (2007)
Remove the anchor plate bolts and position the brake caliper and anchor plate assembly aside.
-
Support the brake caliper and anchor plate assembly using mechanic's wire.
5. Remove the 2 brake disc bolts and the brake disc.
6. Remove and discard the grease cap.
7. Remove and discard the wheel hub nut and remove the wheel hub and bearing assembly.
All wheel drive (AWD) vehicles
8. Remove the wheel knuckle.
9. Using the special tool, press the wheel hub from the wheel bearing.
10. NOTE: This step may be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Install the special tool, position in a suitable press and press the inner wheel bearing race from the wheel hub.
11. Remove the span ring.
12. Using the special tool, press the outer wheel bearing race from the wheel knuckle.
Installation
AWD vehicles
1. Using the special tool, press the wheel bearing into the wheel knuckle.