Fusion FWD L4-2.3L VIN Z (2007)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
CAUTION: Do not allow any brake fluid or foreign material to enter the mating side of the ABS module or damage to the solenoids can occur.
1. Disconnect the battery ground cable.
2. Remove the degas bottle.
3. Disconnect the anti-lock brake system (ABS) module electrical connector.
4. Remove the 3 ABS module screws and the ABS module.
^
To install, tighten to 2 Nm (18 inch lbs.).
5. NOTE: Visually inspect the ABS module terminals for damage before installation.
To install, reverse the removal procedure.
