Fusion FWD L4-2.3L VIN Z (2007)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the retainers and position the fender splash shield aside.
3. Disconnect the wheel speed sensor electrical connector.
4. Remove the 2 wheel speed sensor harness bracket bolts.
^
To install:
-
Tighten the bracket-to-wheel knuckle bolt to 23 Nm (17 ft. lbs.).
-
Tighten the bracket-to-body bolt to 7 Nm (62 inch lbs.).
5. Remove the front wheel speed sensor bolt from the knuckle and remove the wheel speed sensor.
