Fusion FWD L4-2.3L VIN Z (2007)
4. Disconnect the power steering pressure switch electrical connector.
5. Remove the power steering pressure line banjo bolt and disconnect the line from the power steering pump.
-
Discard the bolt and 2 seals.
-
To install, tighten to 48 Nm (35 ft. lbs.).
6. Remove the 3 power steering pump bolts and the power steering pump.
-
To install, tighten to 24 Nm (18 ft. lbs.).
7. CAUTION: A new bolt and new seals must be installed any time the power steering pressure line is disconnected from the power steering pump.
To install, reverse the removal procedure.
8. Fill the power steering system.
