Fusion FWD L4-2.3L VIN Z (2007)
7. NOTE: RH side shown, LH side similar.
Remove 4 screws from each side and position the RH and LH fender splash shield aside.
8. NOTE: RH side shown, LH side similar.
Remove the 6 pin-type retainers (4 shown) from the LH and RH splash shield.
9. If equipped, remove the bolts and the underbody splash shield.
10. Remove the 2 outer tie-rod end cotter pins and nuts.
-
Discard the cotter pins.
11. CAUTION: Do not use a hammer to separate the outer tie-rod end from the wheel knuckle or damage to the wheel knuckle may result.
Using the special tool, separate the outer tie-rod ends from the knuckle.