Fusion FWD L4-2.3L VIN Z (2007)
7. Remove the 6 pin-type retainers (4 shown) and the RH splash shield.
8. Remove the 6 pin-type retainers (4 shown) and the LH splash shield.
9. If equipped, remove the bolts and the underbody cover shield.
-
To install, tighten 7 Nm (62 inch lbs.).
10. Remove and discard the 2 catalytic converter manifold-to-exhaust flexible pipe nuts and separate the exhaust flexible pipe.
-
To install, tighten to 40 Nm (30 ft. lbs.).
11. Using 2 suitable jack stands, support the rear of the subframe assembly.
12. NOTE: RH shown, LH similar.
Remove and discard the 4 subframe bracket-to-body bolts, the 2 subframe bracket-to-subframe nuts and washers. Lower the rear of the subframe.
-
To install, tighten the bolts to 103 Nm (76 ft. lbs.).