Fusion FWD L4-2.3L VIN Z (2007)
Note: Front Wheel Drive (FWD) Shown, All Wheel Drive (AWD) Similar.
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
1. Remove the spring.
2. Remove the cam adjuster nut, cam adjuster, cam bolt and the lower arm.
-
Discard the nut.
-
To install, tighten to 101 Nm (74 ft. lbs.) with the suspension at the bushing fastener tightening position.
3. CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position. Use a suitable
