Fusion FWD L4-2.3L VIN Z (2007)
Remove the bolts and the underbody shield, if equipped.
-
To install, tighten to 7 Nm (62 lb-in).
3. Remove the exhaust flexible pipe.
4. Remove the 2 bolts and the heat shield.
All vehicles
5. Remove the bolt from the engine roll restrictor.
-
To install, tighten to 90 Nm (66 lb-ft).
6. Remove the 4 screws and position the RH fender splash shield aside.
7. Remove the 6 pin-type retainers and the RH front structure-to-subframe splash shield.
8. Remove the 4 screws and position the LH fender splash shield aside.