Fusion FWD L4-2.3L VIN Z (2007)
2. Position the insulation in place over the selector lever cable grommet.
3. Position back the RCM wiring harness and install the fasteners on the studs.
FNR5 transaxle
4. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Position the selector lever cable in the bracket.
5. Install the selector lever cable end on the manual lever.
