Fusion FWD L4-2.3L VIN Z (2007)
12. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.
13. Remove the 2 lower bolts for the rear transaxle insulator and remove the insulator.
Installation
All vehicles
1. Clean the rear transaxle mount bolts using a wire brush and apply new threadlock to the threads.
2. Position the transaxle mount in place and install the 2 lower bolts.
-
Tighten to 62 Nm (46 ft. lbs.).
3. Position the LH front structure-to-subframe splash shield in place and install the 6 pin-type retainers.
