Fusion FWD L4-2.5L Hybrid (2010)
NOTE: This procedure applies to Fusion/Milan with Sony(R) sound and MKZ with THX(R) sound only. For all other amplifiers, refer to the
appropriate procedure.
1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Remove the 4 pushpins and the RH luggage compartment trim panel.
3. Disconnect the audio DSP module electrical connectors.
4. Remove the 3 bolts and the audio DSP module.
-
To install, tighten to 9 Nm (80 lb-in).
5. To install, reverse the removal procedure.
-
Download the configuration information to the audio DSP module. For additional information, refer to PMI in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Audio Control Module (ACM)
Audio Control Module (ACM) - Fusion, Milan
NOTE: Without navigation shown, with navigation similar.
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Control
Module (ACM) Self-Diagnostic Mode See: Procedures/Audio Control Module (ACM) Self-Diagnostic Mode.
All vehicles
1. NOTE: Module configuration is required when a new ACM is being installed.
Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information
Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Vehicles with navigation
