Fusion FWD L4-2.5L Hybrid (2010)
Removal and Installation
All vehicles
1. Remove the front door inside handle screw cover.
2. Remove the front door inside handle screw.
Fusion and Milan
3. Remove the front door inside handle bezel screw cover.
4. Remove the front door inside handle bezel screw.
5. Remove the front door inside handle bezel.
-
Lift upward on the rear of the front door inside handle bezel.
-
Disconnect the electrical connector.
All vehicles
6. Remove the front door trim panel upper screw.
7. Remove the front door trim panel lower screw.
8. Remove the front door trim panel center screw.
-
Fusion/Milan is located behind the inside door handle bezel.
-
MKZ is located above the map pocket.
9. NOTE: The back of the front door trim panel shown with the location of the pin-type retainers.
