Fusion FWD L4-2.5L Hybrid (2010)
Using a suitable trim tool, release the two side air bag module wire harness pin-type retainers from the back of the seat cushion frame.
18. Remove the safety belt buckle and pretensioner from the seat cushion frame. See Figure 12.
1. Release the seat cushion trim cover inboard J-clip.
2. Remove the black safety belt buckle and pretensioner electrical connector cover and disconnect the yellow electrical connector.
3. Disconnect the white safety belt buckle switch electrical connector.
4. Remove the two safety belt buckle and pretensioner nuts.
19. NOTE: For proper routing during assembly. note the routing of the lumbar cable and retainers.
If equipped with manual lumbar remove the manual lumbar control from the seat cushion frame. See Figure 13.
1. Remove the two screws and separate the lumbar control from the seat cushion frame.
