Fusion FWD L4-2.5L Hybrid (2010)
13. Remove the TED exhaust duct.
-
Cut and remove the tie strap.
-
During installation, install a new tie strap.
-
Remove the pin-type retainer and separate the exhaust duct from the TED.
14. Disconnect the backrest upper support spring from the backrest frame and remove the spring support with the TED attached.
15. If necessary, detach the backrest TED filter from the TED.
16. NOTE: Note the TED position on the support spring for installation.
Use an appropriate tool and separate the TED from the upper backrest support spring.
17. NOTICE: Cover the Thermo-Electric Device (TED) openings before removing any rivets to prevent foreign material from entering the
TED.
Remove the 3 rivets and bracket from the TED.
18. WARNING: If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed,
install a new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in
the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
WARNING: Inspect the seat side air bag module and mounting surfaces for any damage or foreign material before installing the seat side
air bag module. If any damage is found, install new components. If any foreign material is found, remove it. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a
crash.
To install, reverse the removal procedure.
