Fusion FWD L4-2.5L Hybrid (2010)
FUSION AND MILAN - DRIVER SEAT BACKREST FRAME REPLACEMENT
WARNING:
Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules Failure to follow this instruction may result in the
accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON
Removal
1. Push the release buttons on the head restraint guide sleeves and remove the head restraint
2. NOTE: If equipped with a power seat, fully raise the seat to aid in bolt removal Position the seat to gain access to all four seat track-to-floor bolts.
3. Depower the Supplemental Restraint System (SRS) For additional information, refer to the WSM, Section 501 20B, SRS Depowering Procedure.
4. Remove the four seat track-to-floor bolt covers and the bolts.
5. Lift the seat to disengage the two forward locators from the floor and tip the seat rearward to access the seat harness electrical connectors.
6. NOTICE: Use care when disconnecting the seat harness electrical connector. Excessive force on the assurance lever can break the connector
mounting.
Disconnect the seat harness electrical connectors and remove the seat
1. Slide and disengage the side air bag module electrical connector locking clip, release the tab and disconnect the side air bag module electrical
connector.
2. Release the locking tab and rotate the assurance lever fully to disengage the seat harness electrical connector.
7. Disconnect the electrical connector.
Disassembly
All Seats
7. If equipped with manual height adjust, remove the handle cover and the screws Pull outward on the handle to remove See Figure 1.
