ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Recall - ECM/ABS Module Reprogramming|Page 5272 > < Recall - ECM/ABS Module Reprogramming|Page 5270
Page 3
background image

^

If you encounter aftermarket equipment or modifications to the vehicle which might prevent the repair of the covered condition call the Special
Service Support Center.

OWNER REFUNDS

^

Ford Motor Company is offering a refund for owner-paid repairs covered by this program if the repair was performed before the date of the Owner
Notification Letter. This refund offer expires July 31, 2010.

^

Non-covered repairs or those judged by Ford to be excessive will not be reimbursed.

^

Refunds will only be provided for the cost associated with reprogramming the PCM and ABS module.

^

Refund Claiming Information (Submit on separate repair line.)

- Program Code: 10B13

- Misc. Expense: ADMIN

- Misc. Expense: REFUND

- Misc. Expense: 0.2 Hrs.

RENTAL VEHICLES

The use of rental vehicles is not authorized for this program.

CLAIMS PREPARATION AND SUBMISSION

^

Enter claims using Direct Warranty Entry (DWE).

^

Refer to ACESII manual for claims preparation and submission information.

^

Related damage must be claimed on a repair line that is separate from the repair line on which the FSA is claimed. Related damage requires prior
approval from the Special Service Support Center.

^

'MT" labor should be submitted on a separate repair line with the related damage flag checked. "MT" labor requires prior approval from the
Special Service Support Center.

^

PROGRAM TERMS: This program will be in effect through . There is no mileage limit for this program.

Attachment II - Labor and Parts Information

LABOR ALLOWANCES

PARTS REQUIREMENTS / ORDERING INFORMATION

Parts are not required to complete this repair.

Attachment III - Technical Information

OVERVIEW

This program involves the reprogramming of both the Powertrain Control Module (PCM) and the Antilock Brakes (ABS) Module to the latest
calibration using IDS release 64.01 or higher.

SERVICE PROCEDURE

Module Reprogramming

NOTE:

Reprogramming concerns! errors may be caused by the following:

^ Data Link Connector (DLC) or Vehicle Communication Module (VCM) becoming disconnected.

^ Allowing the IDS to enter any type of sleep mode.

Recall - ECM/ABS Module Reprogramming|Page 5272 > < Recall - ECM/ABS Module Reprogramming|Page 5270