Fusion FWD L4-2.5L Hybrid (2010)
All vehicles
6. Remove the brake fluid reservoir pin bolt and the brake fluid reservoir.
-
To install, tighten to 6 Nm (53 lb-in).
7. Remove and discard the 2 brake fluid reservoir seals.
8. NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.
To install, reverse the removal procedure.
-
Bleed the brake system. For additional information, refer to Brakes and Traction Control.
-
If equipped with a manual transmission, bleed the clutch master cylinder. For additional information, refer to Manual Transmission/Transaxle
&/or Clutch, M/T.
