Fusion FWD L4-2.5L Hybrid (2010)
Instrument Panel Control Module: All Technical Service Bulletins
Instruments - Defaults To 'Enlighten Mode'
TSB 10-15-5
HYBRID ONLY-INSTRUMENT CLUSTER DISPLAY- DEFAULT TO ENLIGHTEN MODE AFTER IGNITION
KEY CYCLE-BUILT ON OR BEFORE 3/2212010
FORD:
2010 Fusion
MERCURY:
2010 Milan
ISSUE
Some 2010 Fusion and Milan Hybrid vehicles built on or before 3/22/2010 may exhibit an Instrument Cluster (IC) display that intermittently changes
back to the default Enlighten Mode setting, efficiency gauge changes to Efficiency Leaves, and Average Fuel Economy defaults to zero without
per[orming a message center reset. If the IC changes to the default settings only after an ignition key cycle, a cluster reprogram is available.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
A vehicle low voltage condition and/or battery disconnect will cause the IC to reset to default settings.
1.
If the IC exhibits any other symptoms than described and/or diagnostic trouble codes are present, do not continue with this article. Refer to
Workshop Manual (WSM), Section 413-00 for diagnostics.
2.
If the IC changes to the default settings only after an ignition key cycle, reprogram the IC to the latest calibration using IDS release 68.03 and
higher. This new calibration is not included in the VCM 2010.7 DVD. Calibration files may also be obtained at www.motorcraft.com.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage IMPORTANT: Warranty coverage limits/policies are
not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
101505A
2010 Fusion Hybrid, Milan
0.3 Hr.
Hybrid: Reprogram The
Instrument Cluster Module
(Do Not Use With Any
Other Labor Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
10849
04
