Fusion FWD L4-2.5L Hybrid (2010)
Making Changes To The TCM Calibration
If the TCM does not complete the reflash after two consecutive attempts, follow the instructions listed below:
1. If the TCM reprogramming aborts during the procedure:
-
Reprogram the TCM again.
-
After the TCM reprogramming is successfully completed, clear the continuous DTCs in the PCM and the TCM.
2. If the TCM reprogramming aborts immediately after the start:
-
Turn the ignition OFF.
-
Disconnect the PCM body/cowl connector, and leave it disconnected.
-
Turn the ignition ON.
-
Start the TCM reprogramming.
-
After the TCM reprogramming is successfully completed, turn the ignition OFF and connect the PCM body/cowl connector.
-
Clear any PCM and TCM DTCs that may have been stored during reprogramming.