Fusion FWD L4-2.5L Hybrid (2010)
Seat Heater Switch: Service and Repair
Seat Control Switch
Seat Control Switch
Removal and Installation
NOTICE: Do not reinstall the cushion side shield or side shield retainers after removal. These are one-time-use items that become damaged
during removal and may not remain attached if reinstalled. Install a new side shield during seat assembly (includes new retainers attached).
1. Remove the front seat. For additional information, refer to Seat - Front See: Body and Frame/Seats/Service and Repair/Seat - Front.
2. Remove the spring clip and manual recliner handle, if equipped.
3. Pull and remove the manual lumbar control knob and seat control switch button(s), if equipped.
4. Remove and discard the cushion side shield and one-time-use retainers.
1. For passenger seat, remove the scrivet.
2. Pull out on the side and rear of the cushion side shield and release the retainers.
-
Separate the wire harness from the cushion side shield.
3. Remove the side shield and any remaining side shield retainers from the seat and discard.
-
For installation, install a new cushion side shield (includes new retainers attached).
5. Disconnect the seat control switch, release the cushion side shield retainers and remove the seat control switch.
6. To install, reverse the removal procedure.
