Fusion FWD L4-2.5L Hybrid (2010)
9. Connect the Cutoff Pressure Sensor Jumper to the cutoff pressure sensor.
10. From the engine compartment, seal the 2 adjacent openings in the cowl using 3M(TM) Strip Caulk-Black part number 08578 or equivalent
11. Route the Cutoff Pressure Sensor Jumper along the ABS harness bundle to the ABS connector. (Figure 5)
12. Raise the vehicle and remove the seven (7) screws and the underbody cover.
13. Disconnect the ABS connector, then release the wire harness pushpin retainer from the support bracket. (Figure 6)
14. Cut the tie strap retaining the wire bundle to the ABS connector.
15. Remove the red terminal lock by pulling it straight outward. (Figure 7)
