Fusion FWD L4-2.5L Hybrid (2010)
4. Turn the crankshaft clockwise until the hole in the crankshaft pulley is in the 3 o'clock position.
5. Remove the cylinder block plug.
6. NOTE: When the crankshaft contacts the Crankshaft TDC Timing Peg, the No. 1 cylinder will be at Top Dead Center (TDC).
Install the Crankshaft TDC Timing Peg and turn the crankshaft clockwise until the crankshaft contacts the Crankshaft TDC Timing Peg.
7. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
8. Remove the bolts and discard the CKP sensor.
Installation
1. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a 6 mm (0.23 in) x 18 mm (0.7 in) standard bolt in the crankshaft pulley.
