Fusion FWD L4-2.5L Hybrid (2010)
2. RH side 2 pins
3. Bottom 2 pins
4. LH side 2 pins
Installation
NOTICE: Carefully install the bezel onto the steering wheel as instructed or damage to the bezel can occur.
1. Position the bezel onto the steering wheel and align the 10 pins with their respective holes.
2. NOTE: The bezel is installed in 2 stages. Stage 1 seats the 10 pins into the steering wheel approximately half-way. Stage 2 fully seats the 10 pins
into the steering wheel.
Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are seated
approximately half-way into the holes.
3. Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are fully seated
into the holes.
4. Install the driver air bag module. For additional information, refer to Restraint Systems.
