Fusion FWD L4-2.5L Hybrid (2010)
Installation
1. Using the Shift Shaft Fluid Seal Installer, install the manual control lever seal.
2. Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.
3. Install the TCM.
-
Tighten to 24 Nm (18 lb-ft).
4. Install the manual control lever.
5. Install the manual control lever nut.
-
Tighten to 12 Nm (106 lb-in).
6. Connect the TCM electrical connector.
