Fusion FWD L4-2.5L Hybrid (2010)
5. Remove the 4 nuts and remove the selector lever.
Installation
1. Install the selector lever and the 4 nuts.
-
Tighten to 20 Nm (177 lb-in).
2. Connect the electrical connector.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull
back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end
is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
Install the selector lever cable in the selector lever housing.
4. Connect the selector lever cable end to the selector lever.
