Fusion FWD L4-2.5L Hybrid (2010)
2. Disconnect the clutch hydraulic tube.
3. Remove the 2 clutch slave cylinder bolts and the clutch slave cylinder.
Installation
1. NOTE: Apply a small amount of grease on the end of the slave cylinder push rod.
Install the clutch slave cylinder and the 2 clutch slave cylinder bolts.
-
Tighten to 19 Nm (168 lb-in).
2. Connect the clutch hydraulic tube.
-
Tighten to 17 Nm (150 lb-in).
3. WARNING: Do not allow the brake master cylinder to run dry during the bleeding operation. Master cylinder may be damaged if
operated without fluid, resulting in degraded braking performance. Failure to follow this instruction may result in serious personal
injury.
Bleed the air from the system. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.
