Fusion FWD L4-2.5L Hybrid (2010)
Back Window Glass Moulding / Trim: All Technical Service Bulletins
Body - Back Glass Moulding Is Loose
TSB 10-16-6
08/30/10
LOOSE REAR WINDOW GLASS MOULDING
FORD:
2010 Fusion
LINCOLN:
2010 MKZ
MERCURY:
2010 Milan
ISSUE
Some 2010 Fusion, Milan and MKZ vehicles may exhibit a loose moulding end at the base of the rear window glass.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
1. Inspect the moulding ends at the lower edge of the rear window glass.
a. If either end of the moulding is loose, proceed to Step 2.
b. If the moulding is damaged or missing, replace the rear window glass. Refer to Workshop Manual (WSM), Section 501-11.
2. Open the luggage compartment lid and remove moulding from the rear window glass.
3. Clean the glass and moulding with Motorcraft® Ultra-Clear Spray Glass Cleaner. (Figure 1)